TDR tester for RJ45 and BNC network cables: Mapping, Continuity, Length, PING, Location, activity simulator

Multifunction tester for RJ45 and BNC copper network with backlit LCD screen and rechargeable battery. List of functions: .

Mapping and localization.

Testing of the sequence, type and length of the UTP cable, rapid detection and localization (in distance from the origin) of the points of failure. Displays the wiring diagram on screen.

Test the type of cable: RJ45 twisted pair, RJ11 telephone line, BNC cable, etc.

Determine the fault point of the RJ45 cable connector from the LOCAL/DISTANCE indicator light.

RJ45 TDR test.

Test of the condition of the cable pairs, length, attenuation, reflectivity, impedance, inclination, etc. Maximum distance 180M.

Coaxial test.

HD coaxial video level meter, can detect the peak value of the TVI/CVI/AHD/CVBS signal, the SYNC value and the burst value.

PING test.

Checks whether the Ethernet port of an IP camera or other network equipment is working normally and whether the IP address is correct.

IP scan: Quickly finds the IP address of the IP camera or other connected network equipment.

Port flashing and identification.

Allows you to simulate activity on a cord to make the LEDs of the switches or network cards flash in order to identify where the cable is connected.

Thanks to the supplied tracer, it is possible to locate a cord in a set of cables.

Link Monitor.

Identifies the network speed and the full/half duplex type.

Contents:

1x central control with large LCD screen,

1x tracer,

1x RJ11 adapter / alligator clips,

1x soft case.

Note that the tester interface is in ENGLISH.