HDMI 1.4 Wall SPLICER for Image Wall on 4 screens. 8 possible combinations, with remote control.

A simple four-screen splicing processor that enables four-screen splicing or single-screen display with one button. It adopts unique embedded hardware design, can accept various image signal source input and is divided and amplified, real-time distortion-free HDMI output.

HDMI image splicing processor can support input screen splicing and picture non-splicing mixed mode，and display on different screens, customers can combine them into any splicing scheme to display by cascading mode. It adopts cutting-edge processing technology such as motion detection and compensation calculation,interpolation operation, edge smoothing processing and clutter signal suppression. The screen after splitting has no delay, no tailing phenomenon, natural smoothness and clear picture quality.

Splicer mode:

1.The device splicer mode is divided by the split screen; the screen is divided from the top to the bottom and from left to right (if special order is required).
e.g.: 2x2 mode stitching:
Input upper left quarter of the screen: HDMI 1 output
Input upper right quarter of the screen: HDMI2 output
Input lower left quarter of the screen: HDMI 3 output
Input screen right lower quarter section: HDMI4 output

2.When the splicing output mode display is less than 4 screen outputs, the remaining output port displays the input screen in full screen.
e.g.: 1x2 mode: HDMI 1 split and splice 1 screen, HDMI 2 split and splice 2 screen, HDMI 3 and HDMI4 display full screen.
e.g.: 1x3 mode: HDMI 1 split and splice 1 screen, HDMI 2 split and splice 2 screen, HDMI3 split and splice 3 screen, HDMI 4 display full screen.

Product features:

Full hardware architecture, no software setting, plug and play.
Support audio input and output.
Support power-off memory function.
The resolution supports 1280*720P @60Hz20* 1080@60Hz40*2160@30Hz. When the output device or input device does not support 4K resolution, the product is adjusted to 4K output and the display is black.
Switching method: remote control ,and panel button switch
8 splicing modes can be changed at will: 1X1, 1X2, 2X1, 1X3, 3X1, 2X2, 1X4, 4X1, etc. The factory default setting is 2*2 splicing mode.