Slim SAS SFF-8643 to 4-port SAS SFF-8482 cable, 80 cm long, with Sideband interface and Amphenol connectors

This cable allows you to connect four SFF-8482 SAS drives to an SFF-8643 SlimSAS interface on a controller card.

Since the SFF-8643 interface carries only data signals and does not provide power, this cable includes two dedicated 15-pin SATA power connectors, which are essential for properly powering the connected SAS drives.

An 8-pin Sideband interface is also included if needed; it can remain unused.

Compatibility:

Compatible with 12Gb/s SAS SSDs featuring a 29-pin SFF-8482 connector.

Compatible with RAID cards, HBAs, and SAS controllers equipped with a SlimSAS SFF-8643 port.

Technical specifications:

SlimSAS breakout cable to 4 x SAS SFF-8482.

Host-side connector: 1 x male SlimSAS SFF-8643.

Device-side connectors: 4 x 29-pin SFF-8482 male connectors for SAS devices.

Additional power supply via 2 x 15-pin male SATA power connectors.

8-pin Sideband auxiliary connector.

Main data cable length: 80 cm.

SATA power cable length: 25 cm.

Supports SAS 12Gb/s per channel depending on hardware used.

Low signal attenuation for optimal data integrity.

High-quality professional Amphenol connectors.

Direct hardware installation without drivers or software.

Important:

SATA power is required for the drives to operate via this interface.